My Profile

Keep Up to Date:
Blog RSS
Blog
Forum RSS
Forum

cylinder

...ther, whose V-12 XJ-S is not seeing very much of the current warm weather here in England. But there is a 6-cylinder model, which, driven gently, can return quite sensible fuel economy. And (this is s...
...een rebuilt before it went for it's nap. Maybe the owner was going to restore and lost interest. It's a six cylinder, three on the tree. The guy who owned it died unexpectedly and his widow is selling...
A friend of mine has a 3 cylinder 1963 hillman minx that's been sitting in his garage for about 20 years. It doesn't run, and we haven't really looked into why it doesn't. What I'm wondering is: Is
...ts still in place. Car is not running at this time as it needs carburetor (original) and brake work (master cylinder blown from being stored). This car is not folding in half but it does need: 1/4's, ...
...erience with the two models and know that the lines are the same or not? I'm fairly certain that the master cylinders are the same as well as the junction blocks and that's about it. Thanks!...
I have an 1938 Morris 14 6 cylinder. The problem I am having is related to the OIL PUMP. When the car is cold, I get 60 - 80 pounds of pressure but when the car is warm, I only get 15 pounds of pres
...y, I was wondering if anyone out there could tell me if I should use any special fluid when honing my brake cylinders, or if I should just do it dry. Thanks- Ian...
...GM car somewhere in the '50s or early '60s for which I could fabricate a mount so that just the nose of the cylinder sticks through the dash, but while it has an accessory terminal it doesn't have an ...
Currently I have a column shift , 6 cylinder, enclosed driveshaft. Want to convert to a floor shifter. Anyone know where I can get one?
I'd really appreciate any advice on mounting the master cylinder for a Model A to '40's Ford hydraulic brake conversion. I'm finishing a conversion started by someone else that has the old Ford master
...valve is stuck open. If so, you have found your problem. If not, next do a compression test to identify the cylinder and make sure that the valves are indeed fully closing on that cylinder. The valve ...
...akes? Is there any way of improving them w/o going to discs? Someone mentioned getting a two-chamber master cylinder. What kind of mileage can I reasonably expect? When i bought it it had the orig b...
I have Ampco upper Cylinder Lubricators FS.
... but will pay for new if I can't find it. Also, I'm looking for recommendations for places to buy shoes and cylinders. And throw in a source for front end kits while you're at it! adTHANKSvance, Dan...
Would it effect the results if I squirted penetrating oil in all the cylinders and then done a compression test? I have sprayed pentetrating oil in the cylinders a few weeks ago and have since turned
I have a '40 Plymouth that I have replaced the Master cylinder, all four wheel cylinders, all of the rubber hoses, and most of the tubing. I have bleed this system until I'm blue in the face. I still
(posted for a friend, please contact him directly) 1948 Alvis TA14 Saloon. For Sale. 1.9 litre, 4 cylinder, OHV. Ideal restoration project. Needs repaint (some stripped to bare metal), no holes, a
Selling fully restored '38 Desoto S5 Sedan. Six cylinder, lt/dk gray, suicide doors, new brakes, recent upholstery, recent servicing. Buyer to transport from Southern Oregon. $6,500.00 OBO.
Page: 1

Copyright © 2006 - Nov 2008 Antique Cars Club